Description
Our most popular waterproof radio mic case used by professional sound engineers worldwide.

This video shows you how to use the TC clamp sealing system as used on all our radio microphone cases. Follow instructions carefully as there is a small trick - leave a gap between the sealing bars before closing the clamp levers.
 
Check size guide.
What's so special about this case?
This case is designed for electronics which require a thin wire to be connected to them at all times.
The special wire-thru clamp at one end allows that wire to stay connected, and be waterproof.
The case is usually used by professionals with specialist electronic devices.
Suits mini radio mics from brands such as Audio Ltd and Audio Engineering Micron.
Key Features
Use all buttons and switches through the case
Also protects from dust, dirt and sand
Supplied with a belt, or you can use your own belt
Like most of our cases it'll float if you drop it in the drink
 
Seals around a wire of up to 1/10th in / 3.5mm diameter
The seams are high-frequency welded to form a super-strong bond.
This case features our TC Aquaclip which makes the case waterproof to IPX6. Temporary immersion is fine, but not continuous immersion.
Important Notes
Cases with this clamp are for surface use only, but will offer protection from temporary submersion. They are not recommended for prolonged immersion.
When not using the case leave the TC clamp open. If not the wire or tube could eventually cause a permanent distortion of the foam, risking leakage.
As long as you follow this instruction the clamp will be watertight with or without a wire/tube.
The supplied belt measures 121 cm (47") when fully extended.
If you need a shorter length, the webbing can be trimmed with sharp scissors or a knife. To prevent fraying, simply heat-seal the cut end.
The maximum thickness of wire/tube around which the TC clamp will seal is 1/10th inch (3.5mm).